LP Xylophone Notes (Job No: 1242)

Out of the whole family of keyboard percussion instruments, xylophones suffer the most with going out of tune.  There are two reasons, first the note bars seasoning, second from being played.

Due to atmospheric changes wooden note bars absorb and release moisture, as the moisture leaves the wood, it takes a bit of matter with it, so the note will always go out of tune even if the instrument is not played.  However this is more evident in marimba bars which are wider, thinner and more extensively arched, whereas xylophone bars are more chunky and tuned to fifths, or should be, but more of that later.

When xylos are played, hard beaters are used, and these damage the surface of the note bar leaving indentations.  Therefore nothing harder than the note bar should be used to play it, so no hard plastic beaters if the piece has lots of fortississimo.  Furthermore the edges of the bars take a battering, and they become frayed.  When the bars are tuned, I have to remove this loose material, which further affects the tuning.  Eventually I run out of wood to tune the bars, or the internal structure of the wood has been softened or split thus killing the sound, so new bars need to be bought or made.

One last bit to finish off, there is a trend now in new instruments towards thinner bars which have been octave tuned as well as using cheaper woods like padouk.  Wrong, wrong, wrong!  Thinner bars don’t give the stacato sound of a xylophone, octave tuning just sounds wrong – a xylophone has a jarring sound, that is what it is for musically, and padouk is even more prone to damage and splitting.  So not only are they not xylophones, but more like piccolo marimbas, they will not last very long – years instead of decades!  Finally, because the bars are so thin, my job of retuning them is severely limited.

So lets get into the job.  First I get a plank of Honduras Rosewood that will do the job.

wpid-wp-1422608145557.jpeg

This is then ripped to give me the width.  I got two lengths out of this plank which is enough to do all the notes.

wpid-wp-1422608240959.jpeg

These batons are then cut down into the lengths required for the note bars, resulting in lots of sticks of wood.   I then plane to faces to get them flat and square.

wpid-wp-1422608379040.jpeg

I can then thickness them to the correct width and depth.  I now have a pile of equally sized sticks of wood.

wpid-wp-1422608526871.jpeg

The next job is to drill the holes for the note cord.  It takes ages to set the drill up so the notes are held in the correct place, and flat on the bed of the vice.  Getting the angle right is the easy bit (if you have the right equipment).  However once everything is set it is quick to drill all the sticks.

wpid-wp-1422608572835.jpeg

I can now put the radius on the edges of the bars.

wpid-wp-1422608880353.jpeg

Now I finally have note bar blanks which can be varnished and tuned.

One comment on “LP Xylophone Notes (Job No: 1242)

Leave a Reply

Your email address will not be published. Required fields are marked *